it is the time to shink about electrical work. First, I covered LED with aluminum pipe and put glue gun to the both ends. this is going to be LED unit for fiber optic. Some is still single, but I put some LED together like below. With red …
Today's work is almost same as the last time. It illuminate the tip of the rear mast. This part also in the same manner as the main wing, and assembled by bonding a part to the tip of the wing. Although the work is the same as the main win…
Today, turn on the wing-tip light. I will make a small light spot at the tip of the wing. Basically, this is the same way as the work that went before at small wings attached to the top of the bow. I thought it was easier to make it lit fo…
Today I will write about the a little work about the Pulsar Cannon. In the kit, three cannon are formed in one piece.Insert the Cannon from the back side of the body, and assembly. But, it is not seen in the characteristics of Reiji Matsum…
I started to make a display based. Since the Arcadia of the kit is small, it's difficult to install the power supply in.Therefore, the installed power to the display base, and then be routed to Arcadia. The kit comes with display base, but…