Today, I will set up the Arduino and AtTiny into the Arcadia. Since AtTiny is sensitive to heat, it is not soldered directly, use a dedicated socket. (Socket) Also, the wiring of this project are not many, I did not use a circuit board, I …

Around this time, I was just doing electrical work. In the previous article, I wrote that to control the LED using with the Arduino and another new device. This is it. This small tip is named AtTiny85, and this is also a programmable micro…

it is the time to shink about electrical work. First, I covered LED with aluminum pipe and put glue gun to the both ends. this is going to be LED unit for fiber optic. Some is still single, but I put some LED together like below. With red …

Today's work is almost same as the last time. It illuminate the tip of the rear mast. This part also in the same manner as the main wing, and assembled by bonding a part to the tip of the wing. Although the work is the same as the main win…

Today, turn on the wing-tip light. I will make a small light spot at the tip of the wing. Basically, this is the same way as the work that went before at small wings attached to the top of the bow. I thought it was easier to make it lit fo…