Bandai MG MS-07B Gouf

Bandai MG MS-07B Gouf (Old Ver.) 7 complete

Bandai Master Grade MS-07B Gouf is completed. I would like to share some pictures. front view rear. I have changed the shape of the head. I have expanded the width of the mouth, also, it has been extended. So now, mouth will overlays on to…

Bandai MG MS-07B Gouf (Old Ver.) 6

Based paint is finished, and put decals, then following is weathering. First, in order to protect the base paint ans decals from weathering, I sprayed clear coat. Once the clear coat is dried, I will start the weathering. I used oil paint …

Bandai MG MS-07B Gouf (Old Ver.) 5

My work came to painting process. Before painting, by spraying the surfacer in overall, to check whether the surface is being processed properly. If found any problems, sanding again, and repeat to the painted the surfacer. If there is no …

Bandai MG MS-07B Gouf (Old Ver.) 4

Today is the body of remodeling. Although I think this kit is very good kit, but to me,, Shoulder width is a little wider and I feel chest also too thick when I compared with my image, (it might just for me,,,) So, I decided make chest a l…

Bandai MG MS-07B Gouf (Old Ver.) 3

Today, I will describe the mono eye. First, I was thinking where to install the battery. I use a 3V battery for medical this time. This is very small, and can be used to illuminate the LED because it is 3V battery If you look at the instru…

Bandai MG MS-07B Gouf (Old Ver.) 2

I start to work Bandai MG Gouf from basic treatment of Energy tube and Heat Rod. Because, I need to sand about 60 small piece for energy tube and 50 for heat rod. If I l will eave it at the end, I may not be able to finish it. I think it …

Bandai MG MS-07B Gouf (Old Ver.)

I would like to introduce another my work that's finished few years ago. This is my 1st Gunpla after I came back to this hobby. I purchesed this MG Gouf for long time ago, may be 15 years? But I did not have time and chance to finish it. F…