Entries from 2013-08-01 to 1 month
I started to make a mono-eye. First, I cut the aluminum pipe with a pipe cutter to make the frame of Mono-Eye. Then, I have to sharpen flat LED's round head. I also sharpen periphery according to the inner diameter of the pipe. LED has bee…
I started assembling the left arm. By connecting a pipe which I cut diagonally, I changed the angle of the arm. During the work to change the angle,I thought way of coming out of claw is not good. The form of the kit, it looks like a clow …
Both legs assembled rough, I began to assemble the body and both arms. I will keep the shape of the original essentially the right arm. However, in the same way as leg, I have to be able to level the arm by cutting the arm where the hits. …
Since I made a GM roughly, I started making the Z'Gok. Joint does not move much the same as GM also Z'Gok. However, this model is a fixed-pose, so pose of Gm by bending the joint by cutting and/or adding. I began to sharpen from the righ…
It is soooo slow, but I am wtill working. I am thinking that I will use both arms as is,,,I hope... It is so simple. At first, I was going to replace the Detail Up Parts just part of the hands, but when I checked detali up parts at hobby s…
The bud came out four days afterward. Furthermore, it became like grass completely three days afterward. If a switch is turned on, a water wheel will also turn. All done!! Thank you for watching.
1. A mat is aligned with the ground and cut off with scissors. After covering with a mat, water is put into a base. Seeds (attachment) are planted on a mat. A bud comes out after around 5days.The spray of the water is sometimes carried out…