Bandai MG MSN-00100 Hyaku-Shiki

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) 8~ painting and a little more work

I noticed that I forgot to up the article about the painting. After I finished all modification and surface treatment, all parts are ready for paint. All parts were set to painting clips. I painted all the parts black first. This will be t…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) Part 7

Today, I would like to share some minor work. The Hyakushiki has a distinctive cylinder on the shins. This is the stock part. I wanted to change the plastic shaft to metal. I was looking for the same diameter stainless steel rod with the k…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) 6 ~panel line(free hand) and hands

Now, I've finished the major work, I'm going to start adding details. Add a panel line to each part. First, draft it with a mechanical pencil. Trace the draft line several times with a snap-blade knife to make a scratch. Use a knife to sli…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) Part 5 ~Modification of the torso (waist)

Last time, I progressed to the point where I finished the most troublesome work. mata1.hatenadiary.jp I thought this was the end of a major revision, but there was a bit more that bothered me. I feel like the body of the kit is a little to…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) part 4~foot modification

Today's topic is only foot modifications. I made the feet narrower. It looks very simple but took a good amount of time. Because the foot is made up of so many parts. I have to cut all the parts and remove the same amount of plastic from e…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) Part 3 ~Body and shoulders modification

The last time, I have done some modifications for the head and face. mata1.hatenadiary.jp I modify the body(chest) part and shoulders this time. The assembles kit part. This part is also made very nice. it is good to go with it without any…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) Part 2 ~Head, Face modification

I started the model kit build from the head. Because this might be the hardest work from the entire work. This is the head just built as following the original instructions. it is made very well. Just looks Hyaku-shiki. But, I would like t…

Bandai 1/100 MG MSN-0100 Hyaku-Shiki (Ver.1.0) Part 1

Hello there. I have not updated this blog for a while. But now, I would like to share another of my work. The new project is an MG Hyaku-shiki build. Now, open the box. Oh,,,, There are too many parts,,, 1st, I built most of the parts to c…