Finally, I started to make a big hole in GM's body. First, I confirmed the hole position with a combination of GM and Z'Gok again. After I confirmed the position, I drilled in the center roughly. I will continue to expand the hole using a …

I thought I just need to make a big hole at GM's body, but I noticed that his shoulder length is too wide. Once I noticed, I want to fix it. So,, I start to make it narrower. First, I cut the sides of the body. Then, I plug the part that w…

I start working to fix the pose of GM. Secure the skirt of GM using the brass rod like I did for Zgok. I made holes in the body, and insert the skirt I glue the plate on the inside of the body to secure by inserting the head and shoulders …

It went into the work of fixing the pose and surface treatment of parts of Z'Gok. After I have fixed in putty all the parts, fix the surface. Use a brass wire and to fix the pose. Assemble all the basic parts, determine the pose. I think Z…

I am going to cut head part from the body, because it is hard to access mono-eye unit to set into the place. 1st, I add styroform plate just below the head. Then styroform pipe is added top of the head. The pipe is not attache the plate, o…

I've fixed the Mono-Eye of Z'Gok. I will enclose from the back side of the pipe with epoxy putty units Mono Eye. There is also a sense of the light-shielding. I also fixed plastic board that I opened the screw holes for Mono Eye fixation a…