Today, turn on the wing-tip light. I will make a small light spot at the tip of the wing. Basically, this is the same way as the work that went before at small wings attached to the top of the bow. I thought it was easier to make it lit fo…

Today I will write about the a little work about the Pulsar Cannon. In the kit, three cannon are formed in one piece.Insert the Cannon from the back side of the body, and assembly. But, it is not seen in the characteristics of Reiji Matsum…

I started to make a display based. Since the Arcadia of the kit is small, it's difficult to install the power supply in.Therefore, the installed power to the display base, and then be routed to Arcadia. The kit comes with display base, but…

Today we will write about the Luminescence of window of the hull. Four square windows that lined beside the the hull. Actually, I am not clear if this is the window or not. In instructions, this place only have been instructed to paint yel…

When I saw this kit, I really would like to illuminate the lantern on top of the rear deck. But, this kit is smaller than I thought, It became difficult work. So small... Because it is impossible to put the LED in it, I made a small light …